| |
TALUSIA HR 70
Description
Marine oils with very high safety margins specially formulated for the cylinder lubrication of slow speed 2 stroke crosshead Diesel engines.
Recommended Uses
TALUSIA HR The most widely used lubricant for engines operating on intermediate or heavy fuels with a high sulphur level.
Properties
Minimal Piston ring and liner wear.
Maximum cleanliness.
Reduced engine maintenance costs.
Extended periods between overhauls.
Quality level
Lubricants of the TALUSIA HR range satisfy the requirements and recommendations of the major engine manufacturers. They have proved their worth in thousand engines working under widely diverse operating conditions.
Technical propertie -
- |
UNITS |
METHOD |
VALUE |
VALUE |
VALUE |
VALUE |
Grade SAE |
- |
- |
50 |
50 |
50 |
50 |
Density at 15¡İC |
g/cm3 |
ASTM D 4052 |
0,940 |
0,945 |
0,955 |
0,955 |
Viscosity at 100¡İC |
cSt |
ASTM D 455 |
20,0 |
20,0 |
20,0 |
24,5 |
Flashing point, open cup |
¡İC |
ASTM D 92 |
220 min |
220 min |
220 min |
220 min |
Freezing point |
¡İC |
ASTM D 97 |
-9 |
-9 |
-9 |
-9 |
T. B. N. |
mg KOH/g |
ASTM D 2896 |
70 |
80 |
100 |
85 |
Available in
Bulk and 185 Kg. Drums.
Hazard Identification
This product is not classified as toxic or hazardous under current legislation.
Handling
Certain minimum precautions to avoid prolonged contact with the skin should be taken when handling. The use of gloves, visors or masks is recommended in order to avoid splashes
Health and safety hazards
Inhalation: Minimum risk of inhalation as it is a non-volatile product.
Ingestion: Does not provoke vomiting. Drink water. Seek medical assistance.
Contact with Skin: Wash with abundant water and soap.
Eyes: Wash with abundant water.
General measures: Seek medical assistance.
Fire fighting measure
No special measures are required.
Fire control: Foams, dry chemicals, CO2, water spray. Do not apply water jet directly as this may cause the product to spread.
Environmental precautions
Danger of physical contamination in the case of spillage (water flows, coastal areas, the ground, etc.) due to its floating capacity and oily consistency which may cause damage to fauna and flora with which it comes into contact. Avoid its penetration into water containers or outlets. Decontamination and cleaning: Treat as an accidental oil spillage. Avoid spreading by using mechanical barriers and eliminate using both physical and chemical means.
Unless otherwise specified, the values cited in technical characteristics should be considered typical. |
|
